I have the Guzzi kit (2S000913), and fitted it today.
It fits the same as on my previous Breva, by removing the lower rear frame spreader, and replacing with a hinged one.
Anyway, you have to remove the through bolt, which in the instructions has a nut on the right side, except mine is threaded into the frame.
The head is made from cheese (mozzarella ?) and it will NOT come undone, not even with a rattle gun.
However, it turned out that it is loctited, and by carefully heating the protruding threads (with my little cooks blowlamp) I managed to get enough heat down it to destroy the loctite, and it finally gave up and undid, without damaging the paint on the frame.
Hope this helps someone!
It fits the same as on my previous Breva, by removing the lower rear frame spreader, and replacing with a hinged one.
Anyway, you have to remove the through bolt, which in the instructions has a nut on the right side, except mine is threaded into the frame.
The head is made from cheese (mozzarella ?) and it will NOT come undone, not even with a rattle gun.
However, it turned out that it is loctited, and by carefully heating the protruding threads (with my little cooks blowlamp) I managed to get enough heat down it to destroy the loctite, and it finally gave up and undid, without damaging the paint on the frame.
Hope this helps someone!