Macdaddygou
Just got it firing!
Does any one have any information on the gauges board layout? I'm having an issue with the stepper motor of the tach, it goes beyond the start limit of 10k and does not return to 0rpm when energized I've check all the signal, power, ground and switched power to the gauges and they are good the speedo
powers up perfectly the tachs not doing the limit cycle correctly and stops where it wants. I have tested everything up to the 30pin connector it all checks out perfectly I believe the issue is on the board and possibly the controller has a failed connection and or component. I would love to know if there is a circuit
diagram out there of the gouge board or if someone has had the same issue and has resolved it please enlighten me.
MG.
powers up perfectly the tachs not doing the limit cycle correctly and stops where it wants. I have tested everything up to the 30pin connector it all checks out perfectly I believe the issue is on the board and possibly the controller has a failed connection and or component. I would love to know if there is a circuit
diagram out there of the gouge board or if someone has had the same issue and has resolved it please enlighten me.
MG.