Donat Santowiak
Just got it firing!
This is my first post from Australia.
Head bolts re tightening.
My bike was a demonstration model with 400k on clock. Dealer offered to do the scheduled 1000k service at 400k.
I am hoping that this has been done. If the head bolts have been re tightened, would it hurt to re tighten them again just in case they were not?. The bike has done 2400k now.
I believe each bolt needs to be loosened individually and immediately re torqued. With the m10 nuts first at 25nm, the recessed hex nuts then tightened to 25nm, the top nut to 28nm and finally back to the 10mm nuts for a 42nm setting. Can some please help with advise.
Regards guzzidon
Head bolts re tightening.
My bike was a demonstration model with 400k on clock. Dealer offered to do the scheduled 1000k service at 400k.
I am hoping that this has been done. If the head bolts have been re tightened, would it hurt to re tighten them again just in case they were not?. The bike has done 2400k now.
I believe each bolt needs to be loosened individually and immediately re torqued. With the m10 nuts first at 25nm, the recessed hex nuts then tightened to 25nm, the top nut to 28nm and finally back to the 10mm nuts for a 42nm setting. Can some please help with advise.
Regards guzzidon