2013 Custom. Removed the battery to replace the air filter and when all back together found my MGCT setting cleared, yellow ABS on dash but no other warnings or service codes.
Went into the calibration screen, 2nd gear @ 18mph for at least 30 seconds, still 'CALIBRATING' flashing on the dash, never accepts and saves.
Tried calibrating when MGCT is set off to 0 and when MGCT is set to 1 with the same results, 'CALIBRATING' won't save.
I've calibrated it at least twice in the past when fitting new tires without issue but this time it's not wanting to calibrate.
Should I disconnect the battery and start over ? Maybe remove the sensors and clean? IIRC they're magnetic and could attract shavings.
Any ideas ? I like to use the cruise control when slabbing it.
Went into the calibration screen, 2nd gear @ 18mph for at least 30 seconds, still 'CALIBRATING' flashing on the dash, never accepts and saves.
Tried calibrating when MGCT is set off to 0 and when MGCT is set to 1 with the same results, 'CALIBRATING' won't save.
I've calibrated it at least twice in the past when fitting new tires without issue but this time it's not wanting to calibrate.
Should I disconnect the battery and start over ? Maybe remove the sensors and clean? IIRC they're magnetic and could attract shavings.
Any ideas ? I like to use the cruise control when slabbing it.