Hey there Guzzi Mavens,
I am in the throws of spec'ing out some new pistons from CP and need to verify the rocker arm ratio.
From previous post I gather the ratio is 1.35:1. Is this correct?
I am having two sets of pistons made. Both the higest domed pistons possible (minimum clearance to head). 2 cams will be used. B10 and Mega X7.
My request is to have the heads blow off at the far end of the run...
1.35 to 1?
Thanks,
Alex
I am in the throws of spec'ing out some new pistons from CP and need to verify the rocker arm ratio.
From previous post I gather the ratio is 1.35:1. Is this correct?
I am having two sets of pistons made. Both the higest domed pistons possible (minimum clearance to head). 2 cams will be used. B10 and Mega X7.
My request is to have the heads blow off at the far end of the run...
1.35 to 1?
Thanks,
Alex