kiwi dave
GT Reference
I'm trying to remove a snap ring retaining the small self-aligning bearing in the eyelet of the CARC on my 1200 Sport. If it was a normal circlip it would be manageable, and it is my intention to replace it with a circlip for easier future removal.
I'm reluctant to attack it with a TIG welder as suggested to me, the bearing is only 26mm diameter, it's rather tight in there. Currently the CARC is still attached to the bike, but I can remove it if necessary.
I'm reluctant to attack it with a TIG welder as suggested to me, the bearing is only 26mm diameter, it's rather tight in there. Currently the CARC is still attached to the bike, but I can remove it if necessary.