I was wondering if someone would please tell me the proper throw out bearing installation.
I replaced the clutch on my Stelvio NTX and when a I was reinstalling the gearbox the small rod and bearing at the rear fell out. It’s the bits that sit right under the slave cylinder.
The rod has a hollow end and not hollow end, which end faces the front of bike?
I have a service manual but it’s not that detailed.
It looks like it can only go 2 ways so I guess it’s 50/50 shot but I’d prefer not to risk it.
Thanks
I replaced the clutch on my Stelvio NTX and when a I was reinstalling the gearbox the small rod and bearing at the rear fell out. It’s the bits that sit right under the slave cylinder.
The rod has a hollow end and not hollow end, which end faces the front of bike?
I have a service manual but it’s not that detailed.
It looks like it can only go 2 ways so I guess it’s 50/50 shot but I’d prefer not to risk it.
Thanks