One of the first things I did once getting my 16-v7II home was to install a H-B ctr. stand. My pre ride routine is to put bike on stand check oil & tire pressures ,then do a circle check while it warms up. Then off we go. @ only 4k mi. I' be had no issues ,a little oil in the air filter housing & some surging during warm up as the engine goes into closed loop so soon . no warning lights or other issues. To the point . While @the dealers I had them do a PADS check (mostly to zero put the adaptive efi ) as a diagnostic . two faults were stored,p0501 & p0502 , ft. & Rr . speed sensors . "signal not plausible". Jokingly the service mgr. said " doing wheelies huh ?" The only thing we could think of was while warming on ctr. stand the rear wheel is rotating . Any one else seen this? I'm now either warming bike on side stand or chocking rear wheel during warm up . I'll probably re check in a few thou. Mi.