jturquette
Tuned and Synch'ed
Hey all. I have installed the GT y-pipe for my Breva 11100 (2007). One thing I noticed was a the O2 sensor wiring was too short for the sensor to be installed in the new location on the new y-pipe. I was able to coax some more wire out, but the wire is tight. Todd (GT legendary moderator) suggested removing the starter motor and snipping the zip tie on the O2 sensor to give a little more play. looking for any advice or pictures or threads with picture that discuss the start removal. Todd mentioned it's just two bolts, but the devil is in the details. It's the little "quirky" things that tend to bite you. For example, not realizing the hex head machined screw is aluminum and stripping the head off (already did that twice on two separate occasions!)
Any tips are greatly appreciated.
Any tips are greatly appreciated.