Got my bike back today from Moto-Nexus in Hendersonville NC and its 600 mile service. Very satisfied with the service and it did not clean out my bank account :woohoo:
I mentioned to Steve the wrench, about the spring at the end of the so called choke cable that it might be found too strong and the cable would be stretching as per post's on this site. As when I first got the bike it was a bear to start. Well it seems that the nut on the end of the cable and the spring were no where to be found, so the cable was moving and not doing anything. Now the lever does not go past the point on the arrow. Before it would almost be pointing to the ground :S
Had the green valve cover gaskets installed but will have to wait for the sump extender until the next oil change as I am suffering from an old Italian disease B) "Myfundsalow". :laugh:
Also came home to find the National Cycle DX wind screen I ordered arrived. Had one on my Bonnie and loved it. Will post pictures when I install it this week some time
Oh, and I finally got my gauge to read F instead of C :woohoo:
Bill
I mentioned to Steve the wrench, about the spring at the end of the so called choke cable that it might be found too strong and the cable would be stretching as per post's on this site. As when I first got the bike it was a bear to start. Well it seems that the nut on the end of the cable and the spring were no where to be found, so the cable was moving and not doing anything. Now the lever does not go past the point on the arrow. Before it would almost be pointing to the ground :S
Had the green valve cover gaskets installed but will have to wait for the sump extender until the next oil change as I am suffering from an old Italian disease B) "Myfundsalow". :laugh:
Also came home to find the National Cycle DX wind screen I ordered arrived. Had one on my Bonnie and loved it. Will post pictures when I install it this week some time
Oh, and I finally got my gauge to read F instead of C :woohoo: Bill
