Beau1K
Tuned and Synch'ed
OK so I have a V7III Racer with riser clip on's. The M-Blaze turn signals replace the bar ends...the wire goes thru the bars but there's nowhere for the wires to come out.
Obviously I have to drill a hole to get the wires out and connect them to the wires going to the existing blinkers...
Question is...where's the best place to drill a hole?!
Does anybody have any photos of their installation showing how they did it? Just wanting to avoid any problems others may have had in the past!
Thanks in advance!
Obviously I have to drill a hole to get the wires out and connect them to the wires going to the existing blinkers...
Question is...where's the best place to drill a hole?!
Does anybody have any photos of their installation showing how they did it? Just wanting to avoid any problems others may have had in the past!
Thanks in advance!