Ciao Guest - You’ve landed at the ultimate Guzzi site. NEW FORUM REGISTRATIONS REQUIRE EMAIL ACTIVATION - CHECK YOUR SPAM FOLDER - Use the CONTACT above if you need help. New to the forum? For all new members, we require ONE post in the Introductions section at the bottom, in order to post in most of the other sections. ALWAYS TRY A SEARCH BEFORE STARTING A NEW TOPIC - Most questions you may have, have likely been already answered. DON'T BE A DRIVE-BY POSTER: As a common courtesy, check back in and reply within 24 hours, or your post will be deleted. Note there's decades of heavily experienced Guzzi professionals on this site, all whom happily give endless amounts of their VALUABLE time for free; BE COURTEOUS AND RESPECTFUL!
Be sure to see the GTM STORE link also above for our 700+ product inventory, including OEM parts and many of our 100% Made-in-SoCal-USA GTM products and engine kits. In SoCal? Click the SERVICE tab above for the best in service, tires, tuning and installation of our products or custom work, and don't miss our GT MotoCycles® (not) art on the BUILDS tab above. WE'RE HERE ONLINE ONLY - NO PHONE CALLS MADE OR RECEIVED - DO NOT EMAIL AND ASK QUESTIONS OR ASK TO CALL YOU.
There is ZERO tolerance on personal attacks and ANY HYPERLINKS to PRODUCT(S) or other competing website(s), including personal pages, social media or other Forums. This ALSO INCLUDES ECU DIAGnostic software, questions and mapping. We work very hard to offer commercially supported products and to keep info relevant here. First offense is a note, second is a warning, third time will get you banned from the site. We don't have the time to chase repeat (and ignorant) offenders. This is NOT a social media platform; It's an ad-free, privately funded website, in small help with user donations. Be sure to see the GTM STORE link above; ALL product purchases help support the site, or you can upgrade your Forum profile or DONATE via the link above.
They are the OEM tires (just under 9K miles on them). I'm assuming the factory balanced them. I'll have to check to see if the weights are still actually present.
Could be pressure... maybe. The manual says for the rear to use "40.61 PSI (280 kPa) (2.8 bar)". But then it goes on to CAUTION...
Yeah, its not the difference in left/right wear that bothers me, but the actual pattern of the wear on the left side, which looks like distinct bulges in the rubber. It was sort of startling to see, and to my eye almost looks dangerous to continue riding on (I will be replacing these tires, in...
On my way home from a multi-day trip today, and noticed (with the help of the angle of the sun) this. Anyone run into such a pattern before? Seems to be more prominent on the left side. My wild speculation is uneven loading of the panniers, but I suppose it could be anything from pressure...
There may be some vendor-specific codes possible, but I would expect the vast majority of them to be industry standard, so a quick google search should find the meaning of the code. I know the errors I've seen on mine are standard ODB codes... nothing specific to Moto Guzzi.
__Jason
I would suggest that anyone with an E4 or E5 bike pick up the cheap-o diagnostic tools that Todd points out in this thread:
https://www.guzzitech.com/forums/threads/obd-ii-port-reader-e4-5-red-diag-plug-guzzis.22548/
For about $25 you can have the tools you need to diagnose error codes...
Here's the original service bulletin that describes the sensor wire re-route. (I've not seen the revised bulletin that describes the sensor replacement).
It might be worth checking the wiring as prescribed in this TSB - it can't hurt, but it might help.
__Jason
...the crank sensor so that it was somewhat separated from the ignition coils, which were apparently interfering with the signal. It seems that in *most* cases, that was sufficient to fix the problem. However, for some hard cases, that was not enough to fix it, and they had to resort to...
Yes, that's hands-off the throttle. If you gave it a little throttle, it would stabilize (like ~2,000 RPM). And this behavior was intermittent - only happened when the engine was hot, and even then... not all the time.
My wild assumption is that the crank sensor clearance was out-of-tolerance...
LOL those sneakers in the vid look like knock-off Air Jordan v1s, but presumably with the Guzzi logo on them? Make sense... they both used wings LOL
Note, however, that MG did actually do a collab with Timberland...
Out of curiosity, you're idle behavior doesn't resemble this at all, does it?
A handful of E5 bikes (including mine) suffered from this problem, which was related to a faulty crank position sensor (CPS), determined after months of triage with the dealer/Piaggio. The fix for this ends up being...
I also noticed up/down/resume not working recently on my E5. It was a bit baffling because I could have sworn I used that functionality before, but it otherwise didn't stop me from using CC, so I got over it. Good to know that it may just need an update.
__Jason
I've always let it sit for a bit before checking. It seems to me that if you check it immediately after shutting off the engine, it will be hard to get a good reading as the oil will be actively settling into the sump, so the level will be in flux at that point.
However, I never totally...
It's just unfortunate that the Ducati customers were able to get a class action suit going and get satisfaction from the company, while Guzzi owners that had the exact same problem were left hanging in the wind. I wonder if there's still a possibility of a class action for Guzzi, or if that...
The consensus I've seen in various forums is that the blisters are actually water leaching through the tank wall due to ethanol. Draining the tank and letting it dry thoroughly (months?) returns it to normal, at which time the tank can be sealed on the inside.
My V11 Sport has a rash of tiny...
Yep, understood. I don’t particularly like such devices, but I got one to have as a “Plan B” in case remapping became problematic. Despite various positive reviews, their promise still seems too good to be true with such a simplistic device.
__Jason
I'd still like to get to the bottom of my occasional misfire errors, but I've been giving some love and attention to the poor neglected Ducati as of late, so I'll probably get back to that later. I've heard rumblings that there may have been updated OEM maps released recently (not positive), so...