Repalcing the front shock seals...I have the seak in and have the right size 'driver' to help 'tap' it into place and it has gone in nicely except...there is slightly less then 1/16th gap on the bottom of the seal where it looks like it should seat on the little 'ridge' below that the seal should (I think) sit on. I've done some pretty strong 'tapping' on it to get it to seat all the way down but am hesitating to tap harder as I dont want to damage the dang seal. It is in level...and the gap is the same all the way round. Does the 'gap' leave open the possibility of leakage or should I leave it alone and reassemble it as is. I have given it some pretty hard bhlows and it does not seem to want to go any further.
Thanks
Thanks