Flay
Tuned and Synch'ed
I'm going to start in on my exhaust air leaks tomorrow. Dealers have had at it but after a few rides, they're always back again (along with the "popping and banging"). All the bolts seem tight enough but my test paper strips still flap in the breeze :S.
Anything I should keep in mind when doing this? I'm assuming the (dis)assembly will be straightforward enough and I've purchased a tube of Permatex Copper to seal everything up with.
The headers are fine, it's mostly the crossover and slip-on's I'll be paying attention to.
Any tips appreciated!
Anything I should keep in mind when doing this? I'm assuming the (dis)assembly will be straightforward enough and I've purchased a tube of Permatex Copper to seal everything up with.
The headers are fine, it's mostly the crossover and slip-on's I'll be paying attention to.
Any tips appreciated!