• Ciao Guest - You’ve landed at the ultimate Guzzi site. NEW FORUM REGISTRATIONS REQUIRE EMAIL ACTIVATION - CHECK YOUR SPAM FOLDER - Use the CONTACT above if you need help. New to the forum? For all new members, we require ONE post in the Introductions section at the bottom, in order to post in most of the other sections. ALWAYS TRY A SEARCH BEFORE STARTING A NEW TOPIC - Most questions you may have, have likely been already answered. DON'T BE A DRIVE-BY POSTER: As a common courtesy, check back in and reply within 24 hours, or your post will be deleted. Note there's decades of heavily experienced Guzzi professionals on this site, all whom happily give endless amounts of their VALUABLE time for free; BE COURTEOUS AND RESPECTFUL!
  • Be sure to see the GTM STORE link also above for our 700+ product inventory, including OEM parts and many of our 100% Made-in-SoCal-USA GTM products and engine kits. In SoCal? Click the SERVICE tab above for the best in service, tires, tuning and installation of our products or custom work, and don't miss our GT MotoCycles® (not) art on the BUILDS tab above. WE'RE HERE ONLINE ONLY - NO PHONE CALLS MADE OR RECEIVED - DO NOT EMAIL AND ASK QUESTIONS OR ASK TO CALL YOU.
  • There is ZERO tolerance on personal attacks and ANY HYPERLINKS to PRODUCT(S) or other competing website(s), including personal pages, social media or other Forums. This ALSO INCLUDES ECU DIAGnostic software, questions and mapping. We work very hard to offer commercially supported products and to keep info relevant here. First offense is a note, second is a warning, third time will get you banned from the site. We don't have the time to chase repeat (and ignorant) offenders. This is NOT a social media platform; It's an ad-free, privately funded website, in small help with user donations. Be sure to see the GTM STORE link above; ALL product purchases help support the site, or you can upgrade your Forum profile or DONATE via the link above.

Brake bleeding issue

Sorry but pushing the pistons in does do something.
It sends the fluid in the system back to the MC, where it can be extracted using Scotts technique.
I was in no way suggesting that you shouldn't strip and rebuild calipers or replace them if needed.
However, following that, the less air that you need to get out the easier things will be.
With the caliper pistons all the way home the volume of air in the system from the MC to the caliper is reduced
Same principle applies to a simple fluid change
It might not make much difference but why not stack the cards in your favour if you're struggling?
 
The corrosion on the outer edge of your piston is not from contact with “wet” brake fluid. That portion of the piston does not normally contact brake fluid. Only the end side does.

That is surface corrosion caused by road salt in the UK most likely.

The side surfaces are exposed to the atmosphere as the pad wears and the piston must press out further to make the pad contact with the rotor.

You can mitigate this by cleaning your brakes and calipers annually with a soft brass bristle brush and 0-0-0-0 steel wool and some good spray brake cleaner. I use a removal / insertion tool, to grab the piston from the inside and rotate it 180 degrees to clean all around.

IMG_3648.jpeg


Look here:

 
Last edited:
Back
Top