Hi folks, I recently replaced my carc output seal with your help. Now I'm replacing the tyre and notice obvious notcyness as you spin the wheel to the point where you can stop the wheel on the bad spot and hear the clicking as you push the wheel forward and back. first you think is it just backlash but it never made these noises before. Bottom line is I guess I should have replaced the output bearing with the seal. I checked my carc number and it was replace under the recall. You'd of though a bearing would last more than 30000m. If I wait and let it develop, if the bearing is failing will it trash the whole carc. There seems no side play on the wheel. How do ya change the bearing? remove the seal then just pull it out with brute force and bearing pullers through the same opening? Then drive the new bearing in carefully using the old one as a drift?
thanks neil
thanks neil