KerryBlue
Just got it firing!
I think I may have a problem.
About a month ago, when I attempted to start the bike, the dash showed ECU Communication fault and the speedo needle oscillated up and down about half way up the dial. I switched off the ignition and then back on again. The error message had disappeared but the speedo needle did the same as before. it stopped. I tried to start the bike, the engine fired but cut out immediately. This happened a couple of times and then it started perfectly and the bike ran faultlessly for a couple of weeks.
Yesterday morning the same thing happened [ but without the ECU error showing]. When I got it started it ran perfectly for the rest of the day.
I'm planning to take the bike to Scotland in May for a week touring the Highlands so I'm a bit concerned.
Is it likely to leave me stranded? Is there anything I should do?
About a month ago, when I attempted to start the bike, the dash showed ECU Communication fault and the speedo needle oscillated up and down about half way up the dial. I switched off the ignition and then back on again. The error message had disappeared but the speedo needle did the same as before. it stopped. I tried to start the bike, the engine fired but cut out immediately. This happened a couple of times and then it started perfectly and the bike ran faultlessly for a couple of weeks.
Yesterday morning the same thing happened [ but without the ECU error showing]. When I got it started it ran perfectly for the rest of the day.
I'm planning to take the bike to Scotland in May for a week touring the Highlands so I'm a bit concerned.
Is it likely to leave me stranded? Is there anything I should do?