tuxracer
Just got it firing!
Well since replacing the speedo sensor (drowned first day I had it) and rocker box gaskets (both sides leaked) my Griso has been going like a good un and I've been loving it..........however another couple of issues have cropped up recently.
I was giving the bike a good wash and polish up yesterday and took the heat shield of the mid pipe to give it a clean. I found a hair line crack just where the pipe is welded to the Y piece. It's not too bad and I can get a mate to weld it up just now but wondered if this is common and whether there is any way of stopping it happening again?
The other issue is a squeaky clutch, started about 500 miles ago but has not got any worse. When you pull the clutch in with the engine off, you can hear it - sounds like a dry release bearing or spring. The clutch still works perfectly well and no problems with gears so far. Has anybody else had this happen and is it likely to develop into a bigger problem?
I was giving the bike a good wash and polish up yesterday and took the heat shield of the mid pipe to give it a clean. I found a hair line crack just where the pipe is welded to the Y piece. It's not too bad and I can get a mate to weld it up just now but wondered if this is common and whether there is any way of stopping it happening again?
The other issue is a squeaky clutch, started about 500 miles ago but has not got any worse. When you pull the clutch in with the engine off, you can hear it - sounds like a dry release bearing or spring. The clutch still works perfectly well and no problems with gears so far. Has anybody else had this happen and is it likely to develop into a bigger problem?