BayareaEMT
Tuned and Synch'ed
I picked up my 2014 California 1400 last week. Bike came with only one original key and I have the user code as well. I found shared maintenance code of 34534 for California 1400.
I got two new blanks from Moto Guzzi dealer which my local locksmith cut and both can turn on ignition. However when I tried following instructions I found on forum, I ended up with red triangle on dash. Only original key works without code but still shows me key symbol upon inserting it. Other two keys only starts the bike if I enter the user code.
Following is what I did:
1) Original key ignition on
2) Went to MENU >> Service (Entered service code >> Change Keys
3) Entered user code
4) Now it showed me Key 1
5) I turned off ignition and removed original key
6) I inserted original key and turned on ignition
7) 2-3 seconds later it showed Key 2
8) I removed Original Key and inserted Key 2
9) Turned ignition ON and then OFF
10) It never asked me to insert 3rd key. Plus at the end of countdown of 20 seconds it gave me red triangle.
I also tried same steps from step6) through 9) above by starting with other keys followed by original keys but no luck.
What am I doing wrong? Nearest dealer is like 60 miles away for me but if that is the only choice then I will go there.
I also disconnected battery for 10 minutes assuming it will clear red triangle but it didn't :-(
I got two new blanks from Moto Guzzi dealer which my local locksmith cut and both can turn on ignition. However when I tried following instructions I found on forum, I ended up with red triangle on dash. Only original key works without code but still shows me key symbol upon inserting it. Other two keys only starts the bike if I enter the user code.
Following is what I did:
1) Original key ignition on
2) Went to MENU >> Service (Entered service code >> Change Keys
3) Entered user code
4) Now it showed me Key 1
5) I turned off ignition and removed original key
6) I inserted original key and turned on ignition
7) 2-3 seconds later it showed Key 2
8) I removed Original Key and inserted Key 2
9) Turned ignition ON and then OFF
10) It never asked me to insert 3rd key. Plus at the end of countdown of 20 seconds it gave me red triangle.
I also tried same steps from step6) through 9) above by starting with other keys followed by original keys but no luck.
What am I doing wrong? Nearest dealer is like 60 miles away for me but if that is the only choice then I will go there.
I also disconnected battery for 10 minutes assuming it will clear red triangle but it didn't :-(
Last edited: