I have lost low beam on my '12 NTX (both lights). High beam is fine but nothing when I switch to low beam. I pulled the right hand bulb (hi/lo) and connected it to a battery and both filaments work fine. I suspect a relay but the actual wiring colours don't match the wiring diagram (grrrrr) so I'm not sure if I am looking at the High Beam relay or the Light Logic relay? The wiring diagram only shows 1 relay with 5 wires (Light logic relay) but my bike has 2 relays with 5 wires (grrrr)??? When I gave one of the relays ( I think it was the start-up maintenance relay) a small tap my low beam lights came on - so it points to a relay problem? Bike is still under warrantee but its a 100km to the dealer so I'm trying to solve the problem myself.
Is there a fuse on low beam? There is a wire that goes from the alternator to the low beam with no fuse. A can't figure out how the Light Logic and Start-up maintenance relays work? I assume it is so the high and low beams do not operate at the same time and to shut the lights off on start up???.
Any suggestions?
Do these relays give problems? I know the OEM relays on the Quota were known for being problematic.
Regards
Alan NZ
Is there a fuse on low beam? There is a wire that goes from the alternator to the low beam with no fuse. A can't figure out how the Light Logic and Start-up maintenance relays work? I assume it is so the high and low beams do not operate at the same time and to shut the lights off on start up???.
Any suggestions?
Do these relays give problems? I know the OEM relays on the Quota were known for being problematic.
Regards
Alan NZ