Just done the first service, did the oils bit last weekend and this week my VDSTS arrived so I have just been playing with that.
Cut a long story short all good, no major problems other than the tappets sound a bit noisy on one side so I'll check them again once things are cold just to be on the safe side.
I reset the TPS with my new toy, was 4.5 now 4.8 that just leaves tick over, I have a tickover of about 1260, warmed up.
I would like to put a tap in the air feed to the stepper motor but it isn't easy to access and I'd like to see clearly what I'm doing.
What is the easiest way to access the stepper motor, do I have to remove the tank?
Anyone done this?
I don't mind doing it if I have to but I don't want to waste time needlessly either.
Any advice appreciated.
Ray
Cut a long story short all good, no major problems other than the tappets sound a bit noisy on one side so I'll check them again once things are cold just to be on the safe side.
I reset the TPS with my new toy, was 4.5 now 4.8 that just leaves tick over, I have a tickover of about 1260, warmed up.
I would like to put a tap in the air feed to the stepper motor but it isn't easy to access and I'd like to see clearly what I'm doing.
What is the easiest way to access the stepper motor, do I have to remove the tank?
Anyone done this?
I don't mind doing it if I have to but I don't want to waste time needlessly either.
Any advice appreciated.
Ray