elkgrichard
High Miler
Have noticed the spark plug caps have a very soft metal clip that fit over the end of the plug, and tend to spread open when pushed onto the plug end. I've noticed they end up loose even after tightening them up with needle nose pliers. As soon as you push the cap back onto the end of the plug the inside wire band spreads back out and end up loose fitting onto the plug. I've never had an issue like this on any other car or motorcycle. I end up using dielectric grease in the hope that it may help the weak electrical connection with these soft metal clips that spread out as soon as you push them onto the plug.
Is there a better fitting wire set from like NAPA that can be used? Part numbers please if you guys have a fix or crossover for this problem.
My concern... it may be difficult to find a 90 degree end to properly fit onto the plug clearing the valve cover properly. Too short too long whatever?
Is there a better fitting wire set from like NAPA that can be used? Part numbers please if you guys have a fix or crossover for this problem.
My concern... it may be difficult to find a 90 degree end to properly fit onto the plug clearing the valve cover properly. Too short too long whatever?