I have removed one of the two alloy nipples from under the tank on a Breva 11. It is part of the petrol spill and drain off. Under the tank this item screws in to a brass bush moulded into the tank acrylic. A tube attaches and runs down to drain.
I have got one off but one stuck. I'm switching tanks to one that is not damaged by ethanol.
The Guzzi part 30103730 costs about GBP 10 which is stupid.
I'm trying to identify the thread and get a cheaper replacement.
The OD is 6.75 mm and the thread pitch is about 1 or 25-26 tpi.
I did not measure a tapper on the thread. I'm guessing it is NPTF thread? In which case it could be 1/4 inch.
I have got one off but one stuck. I'm switching tanks to one that is not damaged by ethanol.
The Guzzi part 30103730 costs about GBP 10 which is stupid.
I'm trying to identify the thread and get a cheaper replacement.
The OD is 6.75 mm and the thread pitch is about 1 or 25-26 tpi.
I did not measure a tapper on the thread. I'm guessing it is NPTF thread? In which case it could be 1/4 inch.