Finally got around to installing a set of Sato rear-sets I bought from Todd last fall. Installation was straight forward. I took the bike for a short 20 km ride to feel-out the ergonomics then came back in to tighten and locktite each bolt to the torques specified. I set the brake pushrod to roughly the same amount of play as the stock unit (checked before I pulled it off).
Now, when I press the pedal down, the rear brake works but the piston in the slave cylinder doesn't push back hard enough to disengage the pedal. Brake light stays on, there's drag on the wheel, and I need to 'toe up' the pedal. Suggestions?
Now, when I press the pedal down, the rear brake works but the piston in the slave cylinder doesn't push back hard enough to disengage the pedal. Brake light stays on, there's drag on the wheel, and I need to 'toe up' the pedal. Suggestions?