Hello Folks,
I can't seem to tighten this hex head at the back of the motor behind the sump. There is no oil drip there but there is a light "smudge" of oil/grease. Is there a seal that this screw tightens against? If I take it out to inspect the thread will I aggravate a fairly grim situation? Only had the bike two weeks so I trust the PO hasn't stripped this thread. Recutting it would prove a nightmare. Been over the manual but can't find reference to the thing. Doesn't appear in the parts list unless I'm looking in the wrong place. I assume that is the clutch housing above(?) Isn't it a dry clutch?
Any suggestions or insights?
I can't seem to tighten this hex head at the back of the motor behind the sump. There is no oil drip there but there is a light "smudge" of oil/grease. Is there a seal that this screw tightens against? If I take it out to inspect the thread will I aggravate a fairly grim situation? Only had the bike two weeks so I trust the PO hasn't stripped this thread. Recutting it would prove a nightmare. Been over the manual but can't find reference to the thing. Doesn't appear in the parts list unless I'm looking in the wrong place. I assume that is the clutch housing above(?) Isn't it a dry clutch?
Any suggestions or insights?