I have a couple of 'issues' that relate to the left handlebar 'light switch'.
First issue: the high beam switch will not remain in the "on" position. Before I attempt to disassemble the switch to see how it is intended to work, have others had this problem and is there a fix?
Second issue: the computer interface button (In the owner's manual, pg26-#12, called the "SET button). Whether using this button to enter the code to access diagnostics, etc. or changing modes when mobile, this button is at best a nuisance, but usually very frustrating - at least on this bike.
Making contact with this switch is a matter of happenstance. I have tried every possible way to press the button and no joy - one never knows if the attempt will be successful. This is especially frustrating when entering the 5-digit access code as to confirm the sequential, rolling number choice one must hold the button down for 2 seconds. When the contact is iffy or intermittent, this most times results in a number change rather than a number set which then requires that you cycle around again to get to the correct number.
I may not be the only one with this problem.
What is prescribed please for this issue?
Thanks in advance.
First issue: the high beam switch will not remain in the "on" position. Before I attempt to disassemble the switch to see how it is intended to work, have others had this problem and is there a fix?
Second issue: the computer interface button (In the owner's manual, pg26-#12, called the "SET button). Whether using this button to enter the code to access diagnostics, etc. or changing modes when mobile, this button is at best a nuisance, but usually very frustrating - at least on this bike.
Making contact with this switch is a matter of happenstance. I have tried every possible way to press the button and no joy - one never knows if the attempt will be successful. This is especially frustrating when entering the 5-digit access code as to confirm the sequential, rolling number choice one must hold the button down for 2 seconds. When the contact is iffy or intermittent, this most times results in a number change rather than a number set which then requires that you cycle around again to get to the correct number.
I may not be the only one with this problem.
What is prescribed please for this issue?
Thanks in advance.