backonabike
Just got it firing!
I did valve adjustments, to 0.15/0.20 mm intake/exhaust. Previously all valves were tight, intakes were 0.10 and exhausts was between 0.10 - 0.15.
After the adjustment, the cold start was fine, but after 1-2 mins of the rpm drops to about 800-900 RPM and the bike dies. I need to do TB balance at this point? or can i get it stable idle by using the TB bypass screw. I can try to do my first TB sync, but I would need the bike to idle. Any suggestions appreciated. thanks.
After the adjustment, the cold start was fine, but after 1-2 mins of the rpm drops to about 800-900 RPM and the bike dies. I need to do TB balance at this point? or can i get it stable idle by using the TB bypass screw. I can try to do my first TB sync, but I would need the bike to idle. Any suggestions appreciated. thanks.