Couldn't find after a search. Do I test as a single phase and treat the red/white as a single contact and the green as a single contact or separately.
Unless I'm doing this incorrectly I don't any readings no matter what combinations I try.
Thanks, Roland
Never mind. Had the meter on the wrong symbol. Both green wire values were the same as the red/white. Either .50/.49 forward bias or OL reverse. Not sure about the regulator. Starts off at 14.1v but slowly drops off to 12/12.5v after about 20 minutes. Stator values are correct but may not be when it gets hot.
Unless I'm doing this incorrectly I don't any readings no matter what combinations I try.
Thanks, Roland
Never mind. Had the meter on the wrong symbol. Both green wire values were the same as the red/white. Either .50/.49 forward bias or OL reverse. Not sure about the regulator. Starts off at 14.1v but slowly drops off to 12/12.5v after about 20 minutes. Stator values are correct but may not be when it gets hot.
Last edited: