sohcfour
Tuned and Synch'ed
All -
I decided I needed a slightly narrower bar and picked up a Rizoma Conical as others have discussed here. I understand the mocking up, the drilling for controls, making sure there is clearance to the tank etc...
What I don't get (and haven't read) is how to I get the hex ends off of the stock 8V bar? The weights came off fine with an allen wrench, but how do I get the grips off past this hex end? Other posts have acknowledged it, but none I read mentioned how to address it.
I imagine I could hack saw it off, but I want to keep this bar in case I want/need to go back...
Thanks!
Matt
I decided I needed a slightly narrower bar and picked up a Rizoma Conical as others have discussed here. I understand the mocking up, the drilling for controls, making sure there is clearance to the tank etc...
What I don't get (and haven't read) is how to I get the hex ends off of the stock 8V bar? The weights came off fine with an allen wrench, but how do I get the grips off past this hex end? Other posts have acknowledged it, but none I read mentioned how to address it.
I imagine I could hack saw it off, but I want to keep this bar in case I want/need to go back...
Thanks!
Matt