Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
KnowFear said:1983 LeMans III with @ 19,000 miles: The engine & transmission are apart to install deep-spline clutch. Do I replace the non-leaking main seals while everything is apart?
If "yes", then how do I remove the engine's rear main seal?
KnowFear said:Would it be bad to use a seal puller like this http://www.amazon.com/Lisle-56750-Seal- ... B0002SRCKG
and simply lever against the end of the crankshaft?
john zibell said:KnowFear said:Would it be bad to use a seal puller like this http://www.amazon.com/Lisle-56750-Seal- ... B0002SRCKG
and simply lever against the end of the crankshaft?
Yes, you will probably scratch the crankshaft then a new seal will ever work again.
KnowFear said:john zibell said:KnowFear said:Would it be bad to use a seal puller like this http://www.amazon.com/Lisle-56750-Seal- ... B0002SRCKG
and simply lever against the end of the crankshaft?
Yes, you will probably scratch the crankshaft then a new seal will ever work again.
What I meant is that the tool would rest on the end of the crank with the hook pointed towards the outer diameter of the seal. The hook would not be anywhere near the sealing surface on the crankshaft.
Rafael said:That cotter pin puller looks good. Do you pull straight out? I've used a smaller 90 degree pick but couldn't get a strong enough grip on it to keep it from coming out of my hand.
Rafael said:thanks John, Boy, I can't remember how I got those out before. If I drilled or not, or if they came out easier because they are smaller. Anyway, do you drill to get the cotter pin puller in or get it past the lip?
KnowFear said:Aargggh. I destroyed the new seal while pressing it on. I wasn't paying close enough attention to the lip and a short section of it folded over. I didn't see that until I removed my pressing piece... After a choice expletive, I drilled another hole, and pulled another main seal <groan>.
So, is it necessary to use the specific Corteco brand seal for the main seal? If not, then I may be able to source a similar seal locally from an industrial supply store. Otherwise I'll be waiting at least week.