guzzihank said:Thanks again for all of the advice. I was able to push down on the exhaust valve with the wooden end of a ball peen and get it to move. So the valve is not stuck. I will wait for the new push rod and should be back in business.
I will be using the 0.15 and 0.25 mm gaps.
While we are at it, I have gotten different numbers for the gap on the point. The Shop manual says 0.42-0.48mm, the guys at Moto International told me 0.35mm. Any thoughts?
Have you pulled out the push rods to see if there is a difference between the exhaust and intake ? there should not be any. don't discount rocker arm or cam issues just yet