Mark Emig Blacksmith
Just got it firing!
Hello all,
Since everyone was very helpful (thank you very much), I have another question I need some help with. I cleaned and rebuilt the carbs on my V50, noticed that one of the throttle cables was no good, which I replaced. I turned the throttle to test, and the slide did not move in the carb that I replaced the cable on. I removed the cable, and found it is about 1-1/2 inches longer than the old one. The slide moves freely. Should I have replaced both cables at once, or is the cable being longer the issue?
Thanks for the help.
Since everyone was very helpful (thank you very much), I have another question I need some help with. I cleaned and rebuilt the carbs on my V50, noticed that one of the throttle cables was no good, which I replaced. I turned the throttle to test, and the slide did not move in the carb that I replaced the cable on. I removed the cable, and found it is about 1-1/2 inches longer than the old one. The slide moves freely. Should I have replaced both cables at once, or is the cable being longer the issue?
Thanks for the help.