Wiring up heated grips and GPS

[Forseti]

Here's my question: does anyone one have any idea why I was not able to find power in either the green, blue or yellow wiring harnesses inside the fairing?

I was installing my new Zumo 660 and wanted to avoid running the wiring back to the harness and/or battery under the seat. I tested all the connectors, after pulling the fairing all the way off, (whew ) and could not find any voltage... Finally wired it to the battery which is a better, unswitched, solution anyway I suppose.

Any ideas?

Thanks so much, Jesse

I would suspect there was no power because the fuse is missing and likely the relay as well.

 

[famo]

Here's my question: does anyone one have any idea why I was not able to find power in either the green, blue or yellow wiring harnesses inside the fairing?

I was installing my new Zumo 660 and wanted to avoid running the wiring back to the harness and/or battery under the seat. I tested all the connectors, after pulling the fairing all the way off, (whew ) and could not find any voltage... Finally wired it to the battery which is a better, unswitched, solution anyway I suppose.

Any ideas?

Thanks so much, Jesse

I would suspect there was no power because the fuse is missing and likely the relay as well.

Dealer seems to confirm this Shrike! They don't install the fuse until/unless the accessory is installed... :side:

Oh well. Funny no one mentioned that anywhere in the GPS/radar thread!

Jesse